欧美激情亚洲激情_夜夜嗨老熟女av一区二区三区_美女羞羞动态图_伊人视频_干老太太视频_欧美性受xxxx黒人xyx性爽_中文字幕久热_a级特黄视频_免费黄在线观看_久久er99热精品一区二区_欧美日韩亚洲二区_叔母诱惑_二区在线播放_黄色av不卡_国产日韩欧美久久

When we operating the drawing machine, we need to know something about the operation requirements, it is also good for our work. So what requirements we should comply with when in the use of wire drawing machine? KANGSIDA machinery will be introduced in detail for us.

We must wear the gloves when we are in working, it can prevent the pieces to burn our fingers, also can avoid the influence on the quality of the products. We need to check the supply of equipment before we start the machine, have a look whether there is air or water. Correct do the installation of the drawing machine belt, testing about the lubrication degree on the elevating screw on the lower shaft, starting the machine before we make sure there is no person above the material outlet.

When the device opened, we should check the swinging belt, we should shut down for refurbishment immediately if appeared un-normal circumstances. We should not start the KANGSIDA mechanical drawing machine and fan dust machine together, the workers should not leave away the machine after it started. If there are two people at work, the person in the back of the operating should not stand at the exit of drawing machine, prevent the pieces flew out and hit him.

We should immediately shut down the machine when there is un-normal situation in operation, and stopped the electricity at the same time. When the device is in the inspection, we should turn off the total power, and should not work, prevent accidents.

Unless noted, mechanical make constant as the original article, welcome reproduced! Reprint please indicate the address, thank you.
Source of the article：http://www.ksdjx.com/